Ditch-witch UtiliGuard Manuel d'utilisateur télécharger pdf (Page 48)

UtiliGuard™ Series Operator’s Manual Service - 47

As Needed

CMW

Transmitter Unit

Change Batteries

Use ten D-cell alkaline batteries or a Lithium-ion battery pack in transmitter.

1. Open battery cover.

2. Insert batteries as shown.

3. Close and tighten battery cover.

4. Check operation. If battery light is flashing

when unit is turned on, then one battery is

incorrectly installed or batteries are weak.

Battery cells inside may vent or rupture. Do not crush, do not heat or

incinerate, do not short circuit, do not dismantle, do not immerse in any liquid. Observe

charging instructions.

To help avoid injury, see battery manufacturer’s safety instructions.

IMPORTANT:

• Installing batteries backwards will

cause damage to batteries and

unit.

• Ensure that door is closed tightly.

• Do not mix new and used batteries.

1 2 ... 43 44 45 46 47 48 49 50 51 52 53 ... 56 57

Pas de commentaire

Ditch-witch UtiliGuard Manuel d'utilisateur Page 48