Ditch-witch UtiliGuard Manuel d'utilisateur télécharger pdf (Page 29)

Locate - 28 UtiliGuard™ Series Operator’s Manual

Prepare

CMW

Select Frequency

The UtiliGuard transmitter can send signals in over 70 frequencies at 5 watt and 12 watt power levels.

Likewise, the receiver can display information in over 70 frequencies. Optimal frequencies for your area

can be configured for each unit using UtiliGuard software. Use the UtiliGuard+ Ambient Noise

measurement application to determine suitable frequencies. Then, use the transmitter and receiver

frequency menus to activate only the frequencies most suited for a particular jobsite. Be aware of these

points:

• Lower frequencies travel farther than higher frequencies.

• Higher frequencies couple onto lines more easily.

• Higher frequencies also couple onto lines other than the target line more easily.

Activate Frequencies

To activate frequencies on the transmitter as well

as the receiver:

1. Navigate to Settings>Frequency menu.

2. Select the frequencies best suited for the

jobsite conditions. When the box is checked,

the frequency is active.

Note: Power, mode, and beacon icons

indicate which mode a frequency is suited for.

3. While locating, press the Frequency button

to toggle between activated frequencies.

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 56 57

Pas de commentaire

Ditch-witch UtiliGuard Manuel d'utilisateur Page 29