Ditch-witch MR90 Manuel d'utilisateur télécharger pdf (Page 96)

MR90 Operator’s Manual Service - 95

As Needed

CMW

Change Screens

Change screens as needed.

1. Pin access flaps (3) back to expose screens.

2. Remove upper screen (1) by tapping wedges

with hammer.

3. Remove lower screen (2) by tapping wedges

with hammer.

4. Replace screens and wedges.

Check Battery

Check battery as needed. Keep battery clean and

terminals free of corrosion.

To clean:

1. Turn battery disconnect switch, if equipped, to

the off position.

2. Ensure that no ignition sources are near

batteries.

3. Loosen and remove battery cable clamps

carefully, negative (-) cable first.

4. Clean cable clamps and terminals to remove

dull glaze.

5. Check for signs of internal corrosion in cables.

6. Apply MPG to terminals after cleaning to reduce corrosion.

7. Connect battery cable clamps, positive (+) cable first.

8. Tighten any loose connections.

9. Ensure that battery tiedowns are secure.

10. Turn battery disconnect switch to the on position.

IMPORTANT: Remove screens from the back of

the unit.

IMPORTANT: Screens are not interchangeable.

Explosion possible. Serious injury or equipment damage could occur.

Follow directions carefully.

To help avoid injury: Do not create sparks and do not short across battery terminals for

any reason.

1 2 ... 91 92 93 94 95 96 97 98 99 100 101 ... 120 121

Pas de commentaire

Ditch-witch MR90 Manuel d'utilisateur Page 96